Exams > Cisco > 350-401: Implementing Cisco Enterprise Network Core Technologies (ENCOR)
350-401: Implementing Cisco Enterprise Network Core Technologies (ENCOR)
Page 17 out of 62 pages Questions 161-170 out of 614 questions
Question#161

Which IP SLA operation requires the IP SLA responder to be configured on the remote end?

  • A. UDP jitter
  • B. ICMP jitter
  • C. TCP connect
  • D. ICMP echo
Discover Answer Hide Answer

A
Reference:
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/46sg/configuration/guide/Wrapper-46SG/swipsla.pdf

Question#162


Refer to the exhibit. What does the error message relay to the administrator who is trying to configure a Cisco IOS device?

  • A. The device received a valid NETCONF request and serviced it without error.
  • B. The NETCONF running datastore is currently locked.
  • C. A NETCONF request was made for a data model that does not exist.
  • D. A NETCONF message with valid content based on the YANG data models was made, but the request failed.
Discover Answer Hide Answer

C

Question#163

Which three methods does Cisco DNA Center use to discover devices? (Choose three.)

  • A. CDP
  • B. SNMP
  • C. LLDP
  • D. ping
  • E. NETCONF
  • F. a specified range of IP addresses
Discover Answer Hide Answer

ACF

Question#164

Which statement about TLS is accurate when using RESTCONF to write configurations on network devices?

  • A. It is used for HTTP and HTTPS requests.
  • B. It requires certificates for authentication.
  • C. It is provided using NGINX acting as a proxy web server.
  • D. It is not supported on Cisco devices.
Discover Answer Hide Answer

C
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/prog/configuration/166/b_166_programmability_cg/b_166_programmability_cg_chapter_01011.html

Question#165

What do Cisco DNA southbound APIs provide?

  • A. interface between the controller and the consumer
  • B. RESTful API interface for orchestrator communication
  • C. interface between the controller and the network devices
  • D. NETCONF API interface for orchestrator communication
Discover Answer Hide Answer

C

Question#166

Which statement about an RSPAN session configuration is true?

  • A. Only one session can be configured at a time.
  • B. A special VLAN type must be used as the RSPAN destination.
  • C. A filter must be configured for RSPAN sessions.
  • D. Only incoming traffic can be monitored.
Discover Answer Hide Answer

B

Question#167

Which feature must be configured to allow packet capture over Layer 3 infrastructure?

  • A. RSPAN
  • B. ERSPAN
  • C. VSPAN
  • D. IPSPAN
Discover Answer Hide Answer

B
Reference:
https://community.cisco.com/t5/networking-documents/understanding-span-rspan-and-erspan/ta-p/3144951

Question#168

Refer to the exhibit.

What is the result when a technician adds the monitor session 1 destination remote vlan 223 command?

  • A. The RSPAN VLAN is replaced by VLAN 223.
  • B. RSPAN traffic is sent to VLANs 222 and 223.
  • C. An error is flagged for configuring two destinations.
  • D. RSPAN traffic is split between VLANs 222 and 223.
Discover Answer Hide Answer

A

Question#169


Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?

  • A. RSPAN session 1 is incompletely configured for monitoring.
  • B. RSPAN session 1 monitors activity on VLAN 50 of a remote switch.
  • C. SPAN session 2 monitors all traffic entering and exiting port FastEthernet 0/15.
  • D. SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.
Discover Answer Hide Answer

A

Question#170

A network is being migrated from IPv4 to IPv6 using a dual-stack approach. Network management is already 100% IPv6 enabled.
In a dual-stack network with two dual-stack NetFlow collectors, how many flow exporters are needed per network device in the flexible NetFlow configuration?

  • A. 1
  • B. 2
  • C. 4
  • D. 8
Discover Answer Hide Answer

B

chevron rightPrevious Nextchevron right