Which mode allows access points to be managed by Cisco Wireless LAN Controllers?
B
A Lightweight Access Point (LAP) is an AP that is designed to be connected to a wireless LAN (WLAN) controller (WLC). APs are ג€lightweight,ג€ which means that they cannot act independently of a wireless LAN controller (WLC). The WLC manages the AP configurations and firmware. The APs are ג€zero touchג€ deployed, and individual configuration of APs is not necessary.
Which two values or settings must be entered when configuring a new WLAN in the Cisco Wireless LAN Controller GUI? (Choose two.)
CD
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?
C
ג€¢ lldp holdtime seconds: Specify the amount of time a receiving device should hold the information from your device before discarding it
ג€¢ lldp reinit delay: Specify the delay time in seconds for LLDP to initialize on an interface
ג€¢ lldp timer rate: Set the sending frequency of LLDP updates in seconds
Reference:
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/12-2_55_se/configuration/guide/3560_scg/swlldp.html
Refer to the exhibit. How does SW2 interact with other switches in this VTP domain?
D
The VTP mode of SW2 is transparent so it only forwards the VTP updates it receives to its trunk links without processing them.
Reference:
https://www.cisco.com/c/en/us/support/docs/lan-switching/vtp/10558-21.html
Refer to the exhibit. Based on the LACP neighbor status, in which mode is the SW1 port channel configured?
B
From the neighbor status, we notice the ג€Flagsג€ are SP. ג€Pג€ here means the neighbor is in Passive mode. In order to create an Etherchannel interface, the (local)
SW1 ports should be in Active mode. Moreover, the ג€Port Stateג€ in the exhibit is ג€0x3cג€ (which equals to ג€00111100ג€³ in binary format). Bit 3 is ג€1ג€ which means the ports are synchronizing -> the ports are working so the local ports should be in Active mode.
Two switches are connected and using Cisco Dynamic Trunking Protocol. SW1 is set to Dynamic Auto and SW2 is set to Dynamic Desirable. What is the result of this configuration?
D
A Cisco IP phone receives untagged data traffic from an attached PC. Which action is taken by the phone?
B
Untagged traffic from the device attached to the Cisco IP Phone passes through the phone unchanged, regardless of the trust state of the access port on the phone.
Reference:
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_40_se/configuration/guide/scg/swvoip.pdf
Which design element is a best practice when deploying an 802.11b wireless infrastructure?
A
Refer to the exhibit. The network administrator wants VLAN 67 traffic to be untagged between Switch 1 and Switch 2, while all other VLANs are to remain tagged.
Which command accomplishes this task?
D
Which two command sequences must be configured on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (Choose two.)
CD
