Exams > Cisco > 350-801: Implementing Cisco Collaboration Core Technologies (CLCOR)
350-801: Implementing Cisco Collaboration Core Technologies (CLCOR)
Page 9 out of 33 pages Questions 81-90 out of 330 questions
Question#81

An engineer configures Cisco Unified Communications Manager to prevent toll fraud. At which two points does the engineer block the pattern in Cisco Unified CM to complete this task? (Choose two.)

  • A. route pattern
  • B. route group
  • C. translation pattern
  • D. partition
  • E. CSS
Discover Answer Hide Answer

CE

Question#82

Given this H.323 gateway configuration and using Cisco best practices, how must the called party transformation pattern be configured to ensure that a proper
ISDN type of number is set?

A.

B.

C.

D.

Discover Answer Hide Answer

C

Question#83

An engineer with ID012345678 must build an international dial plan in Cisco Unified Communications Manager. Which action should be taken when building a variable-length route pattern?

  • A. reduce the T302 timer to less than 4 seconds
  • B. configure single route pattern for international calls
  • C. create a second route pattern followed by the # wildcard
  • D. set up all international route patterns to 0.!
Discover Answer Hide Answer

A

Question#84

An engineer configures local route group names to simplify a dial plan. Where does the engineer set the route groups according to the local route group names that are configured?

  • A. CSS
  • B. route pattern
  • C. device pool
  • D. route list
Discover Answer Hide Answer

D

Question#85

A collaboration engineer must configure Cisco Unified Border Element to support up to five concurrent outbound calls across an Ethernet link with a bandwidth of
160 kb to the Internet Telephony Service Provider.
Which set of commands allows the engineer to complete the task without compromising voice quality?

  • A. dial-peer voice 1 voip translation-profile outgoing Strip9 max-conn 5 destination-pattern 91[2-9]..[2-9]ג€¦ג€¦$ session protocol sipv2 session target ipv4:142.45.10.1 dtmf-relay rtp-nte sip-notify sip-kpml
  • B. dial-peer voice 1 voip translation-profile outgoing Strip9 max-conn 5 destination-pattern 91[2-9]..[2-9]ג€¦ג€¦$ session protocol sipv2 session target ipv4:142.45.10.1 dtmf-relay rtp-nte sip-notify sip-kpml codec ilbc mode 20
  • C. dial-peer voice 1 voip translation-profile outgoing Strip9 max-conn 5 destination-pattern 91[2-9]..[2-9]ג€¦ג€¦$ session protocol sipv2 session target ipv4:142.45.10.1 dtmf-relay rtp-nte sip-notify sip-kpml codec aacld
  • D. dial-peer voice 1 voip translation-profile outgoing Strip9 max-conn 5 destination-pattern 91[2-9]..[2-9]ג€¦ג€¦$ session protocol sipv2 session target ipv4:142.45.10.1 dtmf-relay rtp-nte sip-notify sip-kpml codec mp4a-latm
Discover Answer Hide Answer

B

Question#86

Which settings are needed to configure the SIP route pattern in Cisco Unified Communications Manager?

  • A. pattern usage, IPv6 pattern, and SIP trunk/Route list
  • B. pattern usage, IPv4 pattern, IPv6 pattern, and description
  • C. pattern usage, IPv4 pattern, and SIP trunk/Route list
  • D. SIP trunk/Route list, description, and IPv4 pattern
Discover Answer Hide Answer

C
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_0_1/ccmcfg/CUCM_BK_C95ABA82_00_admin-guide-100/
CUCM_BK_C95ABA82_00_admin-guide-100_chapter_0100111.pdf

Question#87

Which call routing pattern is used for phone numbers that are in the E.164 format?

  • A. \+.! Route Pattern
  • B. \+.! Translation Pattern
  • C. /+.! Route Pattern
  • D. \+1.[2-9]XX[2-9]XXXXXX Called Party Transformation Pattern
Discover Answer Hide Answer

D
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/collab12/collab12/dialplan.html#pgfId-1591747

Question#88

Which two recommendations are made to optimize Cisco UCM configuration to reduce the number of toll fraud incidents in an organization? (Choose two.)

  • A. Classify all route patterns as on-net and prohibit on-net to on-net call transfers in Cisco UCM service parameters.
  • B. Classify all route patterns as off-net and prohibit off-net to off-net call transfers in Cisco UCM service parameters.
  • C. Classify all route patterns as on-net or off-net and prohibit off-net to off-net call transfers in Cisco UCM service parameters.
  • D. Inbound CSS on any gateway typically should have access to internal destinations and PSTN destinations.
  • E. Inbound CSS on any gateway typically should have access to internal destinations only and not PSTN destinations.
Discover Answer Hide Answer

BE

Question#89

Which wildcard must an engineer configure to match a whole domain in SIP route patterns?

  • A. .
  • B. !
  • C. @
  • D. *
Discover Answer Hide Answer

D
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_0_1/ccmcfg/CUCM_BK_C95ABA82_00_admin-guide-100/
CUCM_BK_C95ABA82_00_admin-guide-100_chapter_0100111.html

Question#90

Multiple route patterns match a number. How does Cisco Unified Communications Managers determine which pattern to use?

  • A. the one that comes first in numerical order
  • B. the one with the longest match
  • C. the one with the closest match
  • D. the one that discards everything PreDot
Discover Answer Hide Answer

C
Reference:
https://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-manager-callmanager/13920-call-routing.html#bcr

chevron rightPrevious Nextchevron right