Exams > Cisco > 300-415: Implementing Cisco SD-WAN Solutions (ENSDWI)
300-415: Implementing Cisco SD-WAN Solutions (ENSDWI)
Page 10 out of 22 pages Questions 91-100 out of 213 questions
Question#91

An engineer is configuring a data policy for IPv4 prefixes for a single WAN Edge device on a site with multiple WAN Edge devices. How is this policy added using the policy configuration wizard?

  • A. In vBond orchestrator, select the configure --> policies screen, select the localized policy tab, and click add policy.
  • B. In vManage NMS, select the configure --> policies screen, select the localized policy tab, and click add policy.
  • C. In vSmart controller, select the configure --> policies screen, select the localized policy tab, and click add policy.
  • D. In vManage NMS, select the configure --> policies screen, select the centralized policy tab, and click add policy.
Discover Answer Hide Answer

B

Question#92

An engineering team must prepare a traffic engineering policy where an MPLS circuit is preferred for traffic coming from the Admin VLAN. Internet should be used as a backup only. Which configuration fulfills this requirement?
A.

B.

C.

D.

Discover Answer Hide Answer

A

Question#93

In a customer retail network with multiple data centers, what does the network administrator use to create a regional hub topology?

  • A. app route policy on vSmart
  • B. data policy on vSmart
  • C. control policy on vSmart
  • D. control policy on vManage
Discover Answer Hide Answer

C

Question#94

Which scheduling method is configured by default for the eight queues in the cloud vEdge router?

  • A. weighted round robin
  • B. priority queue
  • C. low latency queue
  • D. weighted random early detection
Discover Answer Hide Answer

A
Reference:
https://sdwan-docs.cisco.com/Product_Documentation/Software_Features/Release_18.1/06Policy_Basics/05Localized_Data_Policy/
Configuring_Localized_Data_Policy_for_IPv4

Question#95

At which layer does the application-aware firewall block applications on a WAN Edge?

  • A. 3
  • B. 5
  • C. 2
  • D. 7
Discover Answer Hide Answer

D

Question#96

What is a benefit of the application-aware firewall?

  • A. It blocks traffic by MTU of the packet
  • B. It blocks encrypted traffic
  • C. It blocks traffic by application
  • D. It blocks traffic by MAC address
Discover Answer Hide Answer

C
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_data_zbf/configuration/xe-16-9/sec-data-zbf-xe-16-9-book/sec-data-zbf-xe-16-9- book_chapter_0100100.html

Question#97


Refer to the exhibit. Which QoS treatment results from this configuration after the access list acl-guest is applied inbound on the vpn1 interface?

  • A. A TCP packet sourcing from 172.16.10.1 and destined to 172.16.20.1 is dropped
  • B. A UDP packet sourcing from 172.16.20.1 and destined to 172.16.10.1 is accepted
  • C. A UDP packet sourcing from 172.16.10.1 and destined to 172.16.20.1 is dropped
  • D. A TCP packet sourcing from 172.16.20.1 and destined to 172.16.10.1 is accepted
Discover Answer Hide Answer

C

Question#98

Which configuration changes the packet loss priority from low to high?
A.

B.

C.

D.

Discover Answer Hide Answer

B

Question#99

Which on-the-box security feature is supported by the Cisco ISR 4451 SD-WAN device and not on vEdge?

  • A. IPsec/GRE cloud proxy
  • B. reverse proxy
  • C. Enterprise Firewall with Application Awareness
  • D. Cloud Express service
Discover Answer Hide Answer

C

Question#100

Which two mechanisms are used to guarantee the integrity of data packets in the Cisco SD-WAN architecture data plane? (Choose two.)

  • A. certificates
  • B. transport locations
  • C. authentication headers
  • D. encapsulation security payload
  • E. TPM chip
Discover Answer Hide Answer

BD

chevron rightPrevious Nextchevron right