DRAG DROP -
Drag and drop the MPLS concepts from the left onto the descriptions on the right.
Select and Place:
Which table is used to map the packets in an MPLS LSP that exit from the same interface, via the same next hop, and have the same queuing policies?
B
You have configured router R1 with multiple VRF’s in order to support multiple customer VPN networks. If you wanted to see the best path for the 10.1.1.0.24 route in VRF Blue, what command would you use?
A
Which of the following OSPF Link State Advertisements (LSA’s) were created for IPV6 and do not apply to IPv4 OSPF networks? (Choose two.)
AD
Router R1 has been configured with a default route like this:
R1#(config) ip route 0.0.0.0 0.0.0.0 10.2.3.1
You want to redistribute this route into OSPF but when you configure the redistribute static command under the OSPF process the default route is not present. What will create a default route in the OSPF routing process?
C
Which one of the following statements regarding Bidirectional Forwarding Detection (BFD) is correct?
A
Which of the following OSPF neighbor adjacency states is applicable only to manually configured OSPF neighbors in a Non Broadcast Multi-Access network?
A
With Internal BGP, there is a requirement for all peers to be logically fully meshed, where all IBGP routers must peer with all other IBGP routers. For scaling purposes, there are two mechanisms that were developed to bypass this requirement. What are they? (Choose two.)
AD
You have configured policy-based routing on router R1 to force some traffic to go over an alternate link. In order to verify the configuration, which debug command should be used to verify that the specific traffic is taking the intended path?
C
Which BGP attribute can be used to influence the path that incoming traffic takes into your AS from other Autonomous Systems?
B
