Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?
C
The highest IP address of all loopback interfaces will be chosen -> Loopback 0 will be chosen as the router ID.
Refer to the exhibit. When running EIGRP, what is required for RouterA to exchange routing updates with RouterC?
A
This question is to examine the understanding of the interaction between EIGRP routers. The following information must be matched so as to create neighborhood. EIGRP routers to establish, must match the following information:
1. AS Number;
2. K value.
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common
Ethernet link.
The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem?
D
In OSPF, the hello and dead intervals must match and here we can see the hello interval is set to 5 on R1 and 10 on R2. The dead interval is also set to 20 on R1 but it is 40 on R2.
Refer to the exhibit. Which two statements are true about the loopback address that is configured on RouterB? (Choose two.)
BC
If all OSPF routers in a single area are configured with the same priority value, what value does a router use for the OSPF router ID in the absence of a loopback interface?
C
The OSPF Hello protocol performs which of the following tasks? (Choose two.)
AC
What are two requirements for an HSRP group? (Choose two.)
AB
Exactly one active router: Only one Active Router per HSRP group will be elected based on highest priority. In case of equal priority, Highest IP address will be elected as Active Router.
One or more standby routers: There can be one or more Standby Routers.
Which two pieces of information can you learn by viewing the routing table? (Choose two.)
CE
Refer to the exhibit. Which route type does the routing protocol Code D represent in the output?
B
An engineer must configure an OSPF neighbor relationship between router R1 and R3. The authentication configuration has been configured and the connecting interfaces are in the same 192.168.1.0/30 subnet. What are the next two steps to complete the configuration? (Choose two.)
BC
