Refer to the exhibit. To which device does Router1 send packets that are destined to host 10.10.13.165?
B
R1 has learned route 10.10.10.0/24 via numerous routing protocols. Which route is installed?
C
Which two minimum parameters must be configured on an active interface to enable OSPFV2 to operate? (Choose two.)
AE
Refer to the exhibit. What commands are needed to add a sub-interface to Ethernet0/0 on R1 to allow for VLAN 20, with IP address 10.20.20.1/24?
B
Refer to the exhibit. What does router R1 use as its OSPF router-ID?
C
OSPF uses the following criteria to select the router ID:
1. Manual configuration of the router ID (via the ג€router-id x.x.x.xג€ command under OSPF router configuration mode).
2. Highest IP address on a loopback interface.
3. Highest IP address on a non-loopback and active (no shutdown) interface.
Refer to the exhibit. The loopback1 interface of the Atlanta router must reach the loopback3 interface of the Washington router. Which two static host routes must be configured on the New York router? (Choose two.)
CE
Refer to the exhibit. After the configuration is applied, the two routers fail to establish an OSPF neighbor relationship. What is the reason for the problem?
C
Refer to the exhibit. Which route type is configured to reach the Internet?
D
Refer to the exhibit. Which path is used by the router for Internet traffic?
B
When OSPF learns multiple paths to a network, how does it select a route?
C
