Exams > Cisco > 200-301: Cisco Certified Network Associate (CCNA)
200-301: Cisco Certified Network Associate (CCNA)
Page 26 out of 80 pages Questions 251-260 out of 791 questions
Question#251

Which WLC interface provides out-of-band management in the Cisco Unified Wireless Network Architecture?

  • A. AP-Manager
  • B. service port
  • C. dynamic
  • D. virtual
Discover Answer Hide Answer

B

Question#252


Refer to the exhibit. The network engineer is configuring a new WLAN and is told to use a setup password for authentication instead of the RADIUS servers.
Which additional set of tasks must the engineer perform to complete the configuration?

  • A. Disable PMF Enable PSK Enable 802.1x
  • B. Select WPA Policy Enable CCKM Enable PSK
  • C. Select WPA Policy Select WPA2 Policy Enable FT PSK
  • D. Select WPA2 Policy Disable PMF Enable PSK
Discover Answer Hide Answer

D

Question#253

Which mode must be set for Aps to communicate to a Wireless LAN Controller using the Control and Provisioning of Wireless Access Points (CAPWAP) protocol?

  • A. route
  • B. bridge
  • C. lightweight
  • D. autonomous
Discover Answer Hide Answer

C

Question#254

Which switch technology establishes a network connection immediately when it is plugged in?

  • A. PortFast
  • B. BPDU guard
  • C. UplinkFast
  • D. BackboneFast
Discover Answer Hide Answer

A

Question#255

Which command on a port enters the forwarding state immediately when a PC is connected to it?

  • A. switch(config)#spanning-tree portfast default
  • B. switch(config)#spanning-tree portfast bpduguard default
  • C. switch(config-if)#spanning-tree portfast trunk
  • D. switch(config-if)#no spanning-tree portfast
Discover Answer Hide Answer

A

Question#256

If a switch port receives a new frame while it is actively transmitting a previous frame, how does it process the frames?

  • A. The new frame is delivered first, the previous frame is dropped, and a retransmission request is sent
  • B. The previous frame is delivered, the new frame is dropped, and a retransmission request is sent
  • C. The new frame is placed in a queue for transmission after the previous frame
  • D. The two frames are processed and delivered at the same time
Discover Answer Hide Answer

C

Question#257


Refer to the exhibit. The entire MAC address table for SW1 is shown here:

What does SW1 do when Br-4 sends a frame for Br-2

  • A. It performs a lookup in the MAC address table for Br-4 and discards toe frame due to a missing entry.
  • B. It floods the frame out or all ports except on the port where Br-2 is connected.
  • C. It Inserts the source MAC address and port into the forwarding table and forwards the frame to Br-2.
  • D. It maps the Layer 2 MAC address for Fa0/3 to the Layer 3 IP address and towards the frame.
Discover Answer Hide Answer

C

Question#258

Which statement about Link Aggregation when implemented on a Cisco Wireless LAN Controller is true?

  • A. To pass client traffic two or more ports must be configured
  • B. The EtherChannel must be configured in ג€mode activeג€
  • C. When enabled, the WLC bandwidth drops to 500 Mbps
  • D. One functional physical port is needed to pass client traffic
Discover Answer Hide Answer

D

Question#259


Refer to the exhibit. An engineer is configuring an EtherChannel using LACP between Switches 1 and 2.
Which configuration must be applied so that only Switch 1 sends LACP initiation packets?
A.

B.

C.

D.

Discover Answer Hide Answer

B

Question#260



Refer to the exhibit. The entire Marketing-SW1 MAC address table is shown here:
What does the switch do when PC-4 sends a frame to PC-1?

  • A. It performs a lookup in the MAC address table and discards the frame due to a missing entry.
  • B. It maps the Layer 2 MAC address to the Layer 3 IP address and forwards the frame.
  • C. It inserts the source MAC address and port into the table and forwards the frame to PC-1.
  • D. It floods the frame out of all ports except on the port where PC-1 is connected.
Discover Answer Hide Answer

C

chevron rightPrevious Nextchevron right