An engineer is configuring data and voice services to pass through the same port. The designated switch interface fastethernet0/1 must transmit packets using the same priority for data when they are received from the access port of the IP phone. Which configuration must be used?
D
Refer to the exhibit. Which change to the configuration on Switch2 allows the two switches to establish an EtherChannel?
C
Refer to the exhibit. An engineer must configure the interface that connects to PC1 and secure it in a way that only PC1 is allowed to use the port. No VLAN tagging can be used except for a voice VLAN. Which command sequence must be entered to configure the switch?
C
Which protocol must be implemented to support separate authorization and authentication solutions for wireless APs?
A
Which port type supports the spanning-tree portfast command without additional configuration?
D
Refer to the exhibit. What are two conclusions about this configuration? (Choose two.)
AE
A Cisco engineer must configure a single switch interface to meet these requirements:
✑ Accept untagged frames and place them in VLAN 20
Accept tagged frames in VLAN 30 when CDP detects a Cisco IP phone
Which command set must the engineer apply?
D
What does a switch use to build its MAC address table?
C
Refer to the exhibit. The EtherChannel is configured with a speed of 1000 and duplex as full on both ends of channel group 1. What is the next step to configure the channel on switch A to respond to but not initiate LACP communication?
D
Which command entered on a switch configured with Rapid PVST+ listens and learns for a specific time period?
D
