Aside from discarding, which two states does the switch port transition through while using RSTP (802.1w)? (Choose two.)
DE
Reference:
https://www.cisco.com/c/en/us/support/docs/lan-switching/spanning-tree-protocol/24062-146.html
DRAG DROP -
Drag and drop the facts about wireless architectures from the left onto the types of access point on the right. Not all options are used.
Select and Place:
Which interface mode must be configured to connect the lightweight APs in a centralized architecture?
C
While the Cisco WLCs always connect to 802.1Q trunks, Cisco lightweight APs do not understand VLAN tagging and should only be connected to the access ports of the neighbor switch.
This is an example switch port configuration from the Catalyst 3750: interface GigabitEthernet1/0/22 description Access Port Connection to Cisco Lightweight AP switchport access vlan 5 switchport mode access no shutdown
Reference:
https://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/69719-wlc-lwap-config.html
Refer to the exhibit. The following must be considered:
✑ SW1 is fully configured for all traffic.
✑ The SW4 and SW9 links to SW1 have been configured.
✑ The SW4 interface Gi0/1 and Gi0/0 on SW9 have been configured.
✑ The remaining switches have had all VLANs added to their VLAN database.
Which configuration establishes a successful ping from PC2 to PC7 without interruption to traffic flow between other PCs?
C
Refer to the exhibit. The network administrator must prevent the switch Cat9K-2 IP address from being visible in LLDP without disabling the protocol. Which action must be taken to complete the task?
C
Refer to the exhibit. An engineer has started to configure replacement switch SW1. To verify part of the configuration, the engineer issued the commands as shown and noticed that the entry for PC2 is missing. Which change must be applied to SW1 so that PC1 and PC2 communicate normally?
C
Refer to the exhibit. Which switch becomes the root of the spanning tree?
Switch 1 -
BID: 32778 0018.184e.3c00 -
Switch 2 -
BID: 24586 001a.e3ff.a680 -
Switch 3 -
BID: 28682 0022.55cf.cc00 -
Switch 4 -
BID: 64000 4e15.8403.08f -
B
DRAG DROP -
Drag and drop the facts about wireless architectures from the left onto the types of access point on the right. Not all options are used.
Select and Place:
Refer to the exhibit. An engineer is configuring a Layer 3 port-channel interface with LACP. The configuration on the first device is complete, and it is verified that both interfaces have registered the neighbor device in the CDP table. Which task on the neighbor device enables the new port channel to come up without negotiating the channel?
D
Refer to the exhibit. Which configuration establishes a Layer 2 LACP EtherChannel when applied to both switches?
A
